Except the the top left buttons that handle the mode, and macro recording stuff do not appear to (they don't light up ), but I do not use those anyways. You’ll also need cleaning supplies: canned air, Q-tips, and rubbing alcohol. The problem is like the title says that most of the keys feel sticky and do not come up quickly after a key press. Since the caps are plastic, soaking them for only a few minutes is safe. A pair of tweezers or small needle-nose pliers will do for the former, and a small flathead screwdriver or thin-bladed pocket knife should work for the latter. Put any dirty key caps in a small glass with a soap and water solution and let them soak for 3 to 5 minutes. But if you’re at your wit’s end and your only other option is to replace your keyboard, it might be worth a shot.įor this, you’ll need a long and thin tool to depress the latch and something small and slightly sharp to pry up the casing. And it may not even work on your keyboard (do some googling to see if yours is PCB-mounted or plate-mounted). For example, if a laptop key acts stuck but is not stuck on the keyboard and nothing has been spilled on the keyboard, then a driver or other piece of operating system software could be the root of the problem. This is difficult, tedious, and honestly, it’s somewhat likely to break the switch and by extension your keyboard. In rare cases, a sticky key is caused by a problem with a computer's software. On certain keyboards-ones with switches mounted to the PCB and not a “plate”-it’s possible to pop the top off, remove the slider and the spring, and manually clean out the plastic housing and the switch. Remember that each switch on your keyboard is a contained unit that’s basically a little plastic box with a spring, a slider, and an electric switch inside.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |